90 Degree Quick Release Connector Semi-Rigid Plastic Fuel Line Insertion Tools
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DIY Tools to insert a 7.89mm ID6 90 degree quick release fuel coupler into 8mm semi-rigid plastic fuel line
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 342
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
I needed to replace a 90 degree quick connect fuel connector that was leaking in my car (not good!). This connector needs to be inserted into some semi-rigid plastic fuel line (PA11-6). As I don't have the official tools to do this, I decided to design (with Fusion 360) and 3D print some of my own to suit. It is a bit of a MacGyver solution, but it works!
The 90 degree connector is supported by the flange on the circular block. The plastic fuel line is clamped in the rectangular blocks with some M5 bolts. I then used a cheap caulking gun to force the connector into the fuel line. I recommend soaking the end of the fuel line in boiling water for a little while to soften the plastic hose as considerable force is required and the fuel line would slip in the clamp when it was not softened.
Print Settings
Print the circular block face up. Print 2 x rectangular clamp blocks.
Rafts:
Not needed
Supports:
Concentric (circular cavity fits the caulking gun piston)
Infill:
60%
Filament:
PLA+
Resolution:
Standard Quality - 0.2 mm