VW/Audi/Skoda/Seat Rear Wiper Puller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed a puller for the rear wiper as it is stuck pretty tight on the motor shaft.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 477
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed a puller for the rear wiper as it is stuck pretty tight on the motor shaft.
It should be suitable for the same type of VAG type rear wiper. I used it on a Skoda Octavia 1Z5 2008. VW, Seat, Skoda and Audi might use a similar or the same type.
You need an M8 bolt and nut with a suitable head. I suggest hex but I personally used philips as well.
Printing Instructions
Use suitable material. PLA can be used for a fit/print test but might not work. Avoid silk filament as the layers do not adhere too well. I had success with PETG, so the printing instructions reflect that experience.
- 10+ Perimeters
- Infill 25% cubic
- No/Low part cooling fan for strong layer adhesion (I used 20%)
- 0.4mm nozzle @ 0.2mm layer height
Instructions for use
ALWAYS USE SAFETY GEAR AS THE PARTS CAN COME APART RIGEROUSLY!
- remove the nut of the wiper with an size 13 key
- insert the puller under the wiper and screw the nut until its holding firmly
- spray the connection with WD-40
- increase the tension slightly and tap the nut with a hammer carefully
- increase the tension, if you hear the layers cracking its enough pressure
- after a while the wiper comes off
DO NOT USE EXTENSIVE PRESSURE! The puller just exerts a constant force and is not suitable for removing the wiper with force!
USE AT OWN RISK