Apex Legends MRB (Mobile Respawn Beacon) miniature

This model was designed in FreeCAD - FOSS (Free and Open-Source Software) 3D parametric modeler. Source file is available.

Warning! “top_b” part (antenna part to be precise) is prone to melting due to its small size. Make sure to use sufficient cooling and print at lower speed. 

Print in red (or colour in red later). I recommend to enable ironing.

Print in black (or colour in black later). Print with 0% infill.

Same here, but with red colour.

Print in white. Either left as is or colour light grey. Set top infill pattern as concentric.

Print in red (or colour in red later). I recommend to enable ironing for topmost surface or concentric top infill pattern.

Print in black (or colour in black later).

Part (1) on the image is difficult to print properly due to the small size of the antenna. It melts with insufficient cooling. You may want to print it separately with increased cooling and with lower speed. Consider using variable layer height for it.

Part (2) on the image can be safely printed with 0% infill.

Vase mode should work fine. Any colour is fine.

Now you may want to glue this model in steps, in order to have something to grip on. Here are the steps.

All red body parts, red thruster parts and red top part. Carefully align them. If you prefer, paint it in red as a single unit.

Paint in black and glue in the remaining body parts, top part and thrusters.

First glue halves of legs (optionally paint in grey), glue to them caps (painted in red). Let them dry. Make sure you glue the legs properly so they will not fall off under the weight of the model.

 Lastly glue the bottom cover.

You may want to paint in black some holes (1, 2, 3, 4) and paint in silver these parts (5).