1 / 6
Prusa MK4S Adapter with 608zz bearing for filament runner — zdjęcie 1
1 / 6

Prusa MK4S Adapter with 608zz bearing for filament runner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Prusa MK4S Adapter with 608zz bearing for Jiltx's filament runner

Ocena
0 / 5
Polubienia
3
Pobrania
12
Wydruki
0
Wyświetlenia
329
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Initially wanted to use jltx's design to have the same functionality but soon realized that the spool would be at an angle and not parallel to the printer.
The hex cut-out model is still provided (as a best effort) in case an extra bearing is not available.
NOTE: !!!! the hex-cutout model needs to be modified, as it doesn't have the required gap and space to fit the frame. It was designed to sit on top of the Z Top piece only. In case it's needed, I can modify it to fit, but as I didn't use it I just didn't bother to do so !!!!

Another solution was to change the hex pattern orientation/angle, but I didn't want to have to print another adapter, if needed.

So, instead of the hex patter, now you can use a 608ZZ bearing and have almost 360* freedom. Also, this meant that one of Jitx's pieces would need to be modified. I chose the runner lift, as it was a one-piece.

The runner itself can be downloaded from Jitx's thingy: https://www.thingiverse.com/thing:2727093 

So... what do you need to make it work:
1. 2 X 608ZZ Bearings
2. the "Prusa MK4S Z-Top-Right piece 608zz bearing carve2" piece
3. the "runner_lift_for_Bearing"
4. [OPTIONAL] Pipe teflon tape, in case the inner diameter is slightly smaller and the runner lift does not have a tight fit
5. the "runner_v2_clearance" or "runner_v2" (from Jitx's page mentioned above) printed twice (as they're halves) 
6. [OPTIONAL] "totally_optional_Kcap" (from Jitx's page mentioned above).

Print options… anything that suits you :)

In my case, I used the Prusament PLA samples that came with the MK4S kit. Printed with the 0.4 nozzle @ 0.1mm.
 

Tagi