Drill bit holder for wall mounting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Metric and inch drill bit holders for wall mounting.
- Ocena
- 5 / 5
- Polubienia
- 46
- Pobrania
- 380
- Wydruki
- 2
- Wyświetlenia
- 1254
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a set of holders for drill bits. The drill bits holder is designed for good visibility and access and easy drill bit removal and insertion, so the holes are oversized by 0.5mm and the holder is tilted by 10 degrees. I have added a couple of extra holes for the narrower drill bits, I like to have some extra because I tend to lose them or they can break off from time to time.
The metric drill bit holder can hold drill bits from 1 to 10 mm in 0.5 mm increments and a variant for drills in the 10.5 - 13 mm range. The inch drill bit holder can hold drill bits from 1/16" to 15/32" in 1/32" increments.
The drill bit holder is screwed to the wall. Use a flat head screw suitable for countersunk holes with a diameter of 3-3.5 mm and a length of around 25-30 mm, but this may vary depending on the type of wall you have.
Printing and print settings
The best way to print the drill bits holder is flat on the bottom side. In the model files the parts are oriented in the best direction for printing. Use PLA for printing with a layer height of 0.2mm or less and a nozzle width of 0.4mm or less. A wall thickness of at least 4 lines and an infill of 25%. A support structure for the screw hole are recommended for the printing.
The numbers are on the top of the model, so it is possible to change the filament colour for the last few layers to make the numbers stand out better.
After printing, the holes may need to be adjusted to the correct size by drilling the holes with a drill bit 0.5mm larger in diameter than the intended drill bit.