1 / 6
Versatile tablet stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
I could not find any tablet stands for my iPad the way I pictured it so decided to design my own. Created this one in Fusion 360.
Printing Instructions
- No supports needed - just make sure to print on the side so it prints vertically as in the 3MF file.
- Print at '0.3mm DRAFT' with 0 infill to make printing faster. Prints in less than 8 hrs on an MK3S. You can add infill to make it heavier.
- I printed it in PETG, add a brim if you're not sure about your first layer adhesion. Better to use brim if you print in PLA.
Design notes
- Viewing angles are 45 deg and 60 deg
- Thickness is 5mm
- 10mm clearance for the tablet - enough for a simple cover
- Total height is 20cm - so it fits in the MK3S
- Can also be used upside down - see photo
Update
Added a version with hearts instead of hexagons, enjoy!
If you print this, please post a make. Feedback and suggestions are appreciated!