Ergonomic grip for Nintendo DS Lite

While corona crisis is preventing us from our usual social activities, the good old Nintendo DS Lite is getting very popular again in our family, after a silent existence in a drawer for almost 10 years... However, it isn't just a pleasure to hold this console in the hand for more than a few minutes - something had to be done to avoid those finger cramps! And here is the outcome: an ergonomic grip that makes it really comfortable to play on the NDS Lite.

Printing of this item should not cause any trouble, I tried with PETG and ABS without problems. If needed, an optional power switch extender can be added, as the NDS Lite power switch is covered by the grip. If you want to turn on and off the console without sliding it out of the grip, you can print the extender and put it in the slot underneath the right grip. Note, that a sharp edge is needed, where the extender hits the power slider on the console, else it will slip off, when pushed. So, fine down a few tenth of a millimeter from the front and top of the extender wedge, that worked perfect for me.