Kinematic Bed Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable magnetic kinematic bed mounts.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 562
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Compact magnetic kinematic bed mounts. Can be used with or without threaded inserts. I originally designed to be used with the Ender 5, using the original screws and springs, replacing the adjustment knobs. Additionally, because these are plastic, minimal heat will be transferred through them to your printer frame.
The stationary mount has a dimple on the bottom, the other is a trough (mount with U groove). Placing a 9-10mm ball in between the two mounts will either hold it's position or allow the bed to expand with little resistance. I place one dimple mount at one corner of the bed and 3 trough mounts on the other corners.
Print with high temperature plastics; ABS, Polycarbonate, Nylon, etc.
When inserting the magnets, make sure they are all matching poles before gluing.
Items needed:
5 - Dimple kinematic prints
3 - Trough kinematic prints
4 - 9mm ball bearings
32 - 3/8" cylinder magnets
High temp Epoxy glue (JB weld or Loctite)
Please “Like”, it helps me, Thank you