Dehydrator/Filament Spool Dryer walls
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Convert your dehydrator to a filament dryer using these walls
- Ocena
- 4 / 5
- Polubienia
- 7
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 307
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So inspired by existing solutions, but unhappy about the tooling (I'm absolutely unfamiliar with fusion 360 and similar tools), I reengineered one of the dehydrator parts in OpenSCAD (I wanted to use an analog display, too).
The code is still messy as hell, and if you have any feedback/improvements for me in that regard, let me know/remix it :)
In my case, it is for a Zelmer ZFD1010 (which required the grooves), for which I uploaded the generated stl. Third picture is from a test print with desired radius (and grooves) but 3cm height.
My dehydrator required cutting into 120° parts (and along with the diameter, it barely fits for my A1 in this configuration). You can change all those variables.
The hole for the sensor fits https://www.amazon.de/dp/B0CLYDJMM9 but is easily adopted to anything else (at least I hope so :D )
If you require assistance adapting, let me know - having reasonably good measurements of the original parts (radius, groove definition, other cutouts …) is required, though.