1 / 3
Amiga A1200 and A600 case clip for Goex display — zdjęcie 1
1 / 3

Amiga A1200 and A600 case clip for Goex display

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount Goex OLED on your Amiga using the filament of your choice

Ocena
0 / 5
Polubienia
4
Pobrania
62
Wydruki
0
Wyświetlenia
243
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

I bought a Goex + OLED display from Centuriontech. Like everything I have received from there it is excellent but the filament used to print the housing for the OLED was not a great match for my case. I have a good opaque white PLA that matches the A1200.net case well so I wanted to print the housing again. When Centuriontech did not respond to my request for a file I designed this, which is better than the original.

  • More care taken to chamfer/finish the edges nicely
  • Goex fits more securely in this model
  • Expanding legs hold the housing in place on the Amiga until you want to remove it

Feed the wires through the Amiga as per original directions. Place the Goex over the pins in the printed housing and fasten it somehow - tiny bit of hot glue, deform the pin slightly with a soldering iron etc. Click it into place on the top of the Amiga and do not forget to unplug the wire when lifting the case off! 

(I don't have an Amiga 500, maybe it would work there too)

Tagi