Cable box for Sonoff POW316D/POW320D
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Provides a cable box at the bottom of a Sonoff POW316D/POW320D making it suitable for use outside of a distribution box.
- Ocena
- 3 / 5
- Polubienia
- 4
- Pobrania
- 43
- Wydruki
- 1
- Wyświetlenia
- 285
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Introduction
Provides a cable box at the bottom of a Sonoff TH/POW 16/20A smart relay to safely enclose cable connections when used outside of a distribution box, such as wall mounting it independently.
Without the cable box, mains connections are reasonably easy to accidentally come in contact with through the cable entry holes in the bottom, and there is no cable strain relief further increasing the chance of conductors becoming exposed. If the device is used in a distribution board this isn't an issue, however if you wish to use it elsewhere such as wall mounted a solution similar to this is advisable.
Printing
This has been designed to be printable without supports and also designed to be printed in a certain orientation. The bottom of the box should be printed with the cable entry holes on the print bed, the top should be printed top face down, and the cable retention bar upside down. To aid with this a single stl with all parts pre-placed on the bed is provided.
Fixings
Designed to be fixed together with 2 M3x20 screws, these should be able to self tap, or you can tap the holes in the base. The cable retention bar should additionally have an M3x12 or M3x16.
The base has two countersunk holes that can take 4mm diameter screws to fix the box to the wall, however these are not required if you intend to used the bracket supplied with the Sonoff device which can still be used with this box.
Design
Designed for cables of around 10-11mm outer diameter, should be suitable for slightly smaller, if significantly smaller a different cable retention bar maybe required. The base is designed to clip onto the Sonoff device, there are two locator pins on the bottom that fit into the screwholes on the sonoff device, generally the part should have enough flex to pull the sides apart to release it however, the tabs on the bottom can be made to flex so it can be slid on and released by leavering the locator pins up. The top will clip into place however this shouldn't be considered the main fixing mechanism and 2 screws should be used.
The Freecad file is also provided should you wish to make any adjustments.