Corsi-Rosenthal 20" Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Entirely 3d printed frame designed to be printed on a MK4 and to house 4 20"x20"x1" furnace filters and a 20" box fan.
- Ocena
- 4 / 5
- Polubienia
- 21
- Pobrania
- 144
- Wydruki
- 1
- Wyświetlenia
- 1916
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Originally designed because my girlfriend is slightly allergic to cat dander and our previous Corsi-Rosenthal was looking a little ragged, this entirely 3d printed frame is designed to hold 4 20"x20"x1" furnace filters in a standard Corsi-Rosenthal configuration with a box fan set on top. I would also recommend using some ½" foam weather sealing strips to both seal against the fan on the top of the model and as feet on the bottom so that it doesn't rattle.
You will need:
- 4 x Mega Corsi-Rosenthal - Bottom Corner
- 4x Mega Corsi-Rosenthal - Top Corner
- 8 x Mega Corsi-Rosenthal - Horizontal Middle
- 4 x Mega Corsi-Rosenthal - Vertical Middle
- 8 x Mega Corsi-Rosenthal - Vertical Clip
- 16 x Mega Corsi-Rosenthal - Horizontal Clip
- 4 x 20"x20"x1" furnace filters, the higher the rating (within reason) the better. Higher ratings will need to be changed more often.
- 1 x 20" Box fan. Save the box to make a shroud on the top and to fill in the bottom of this frame. See original Corsi-Rosenthal instructions for more details.
- ½" foam weather sealing tape
I do not remember how long this took to print but I do seem to remember the frame segments took a whole 1kg if not more. All of the black components are PLA and the orange are PETG, though I do not think it matters and all were sliced at .2mm layers as fast as I could get them without any supports.
This model was designed in Onshape and is accessible for modifications here.