1/4" Pegboard to M3x16 Anchor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A tiny print that allows you to screw in a M3x16 bolt to a 1/4" diameter pegboard
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 261
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
A super quick print that allows you to put a M3x16 bolt into ¼" pegboard. It's great for mounting things that already have mounting keyholes on to pegboard.
This thing is way stronger than it looks. The secret to this model is that as you screw the bolt into the soft-ish PLA, it expands on the rear of the pegboard wedging itself into the rear of the pegboard. Really, it's not going anywhere.
Print instructions
Put it on the print bed and go - make sure and orient the flatter side to the bed. No supports needed. I've found this prints best with a 0.15 layer height, although I've done it with a 0.2 and it still works.