M5C Tapo C100 Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is V5 of my Camera Mount, meant to be used with a Tapo C100/C110/TC60 wifi camera on an AnkerMake M5C.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 436
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Okay, so i wanted a cheap camera to monitor my prints. I got a Tapo C100 and it's great. It's cheap, the app is very good, but most importantly: it streams via RTSP. So you can stream that camera from basically everywhere (not only the app!).
I wanted a decent looking mount, but didn't find any. So i remixed this.
It comes in two versions:
- V5: The camera will sit at bed level - better view on the nozzle.
- V6: The camera will sit above bed level - better view on the bed.
The camera will sit upside down in the mount. There is an option to turn the picture upside down in the app! So you will get an upright picture.
I used:
- PLA
- 5mm brim
- organic supports (1st layer extended to 8 mm)
- 70% infill
- normal speed