Rat Bait Station
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
I found I needed a rat bait station as the rats in the area are out of control.
So I designed one in openscad.
The model is pre cutup into printable sized chunks.
Printing:
I printed with a 0.4 nozzle and 0.35mm layers.
The tee requires support.
You need two of the body extensions and one of the rest.
I used PLA, time will tell if the rats prefer the PLA to the bait.
To use just hang bate on a stiff wire from the cap down the feeder tube. As each block is consumed a new one falls down the wire to replace it.
The tolerance in the joiners is a little sloppy, needs glue. But good enough. Source is included, so if you want better, feel free to edit to.
Print instructions
Category: Outdoor & Garden