Seeed T-1000E Charge Dock (MeshToaster)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Desktop charging dock that supports multiple cards, uses OEM charge cable.
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 150
- Wydruki
- 5
- Wyświetlenia
- 1019
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I can't explain how satisfying this is to use. The magnetic pogo pins will suck the card from your hand as it seats into the dock. If your card is turned off, it will wake and begin charging as soon as it sees USB power. If you have multiple cards, you can use a USB hub to update several at once without swapping cables around.
This uses the OEM charging cable that comes with the cards. All parts lay flat on the print bed with no supports needed. Push the pogo side of each USB cable through the rear cover and assemble the stack from back to front.
You will need a front/back for each card, they can infinitely stack (until you run out of room for cables), and you print one front and back cover to close it off. Hardware is M3, will need M3x10 to attach the card holder halves together, and I used M3x8 for the sides.
Remixes welcomed, I could see this being converted into a snap-together assembly but I like the ability to disassemble if needed without risk of breaking the parts.