Meanwell LRS-100 Terminal Cover and Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalist cover and mount for protecting the terminals of an LRS-100 series power supply.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 632
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a minimalist design for mounting and protecting the terminals of a Meanwell LRS-100 series power supply. It relies on a C14 socket for input voltage, and provides holes in the front of the cover for output wiring (grommets recommended to minimize strain on the wiring) and access to the voltage adjustment screw.
You'll need a few screws (metric, but I'll have to check whether they're M2 or M3, I think the latter) to attach the printed parts to the case…the printed parts have holes for the threaded mount points on the case. Be sure to only use screws just long enough to catch the threads, to avoid contacting anything inside the case that you shouldn't.
----
IMPORTANT - This design is NOT intended for use where it may be accessible to small children or anyone who might be tempted to put something in the case of the PSU. It is intended to protect the mains power terminals from accidental or casual contact, and does not afford any protection from someone poking conductive objects into the upper part of the case.
----
Also, should be obvious from the design, but this is NOT suitable for outdoor use.
USE AT YOUR OWN RISK!
I'm including 3MF files for both the terminal cover and the mount…these may work for other MW power supplies (such as the LRS-150 series), but I've only tested the fit on the LRS-100-5.
I am also including STEP files of the design, in case anyone would like to modify the design to better suit their needs.