Headphone Measurement Stand for IEC 60318 and GRAS KB006x
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DIY stand for headphone measurements and acoustic research. Fits IEC 60318-4 ear simulator coupler and GRAS KB006x pinna
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 544
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
3D printable DIY solution for creating headphone measurements and acoustics research. It is designed to fit the IEC 60318-4 ear simulator coupler and GRAS KB006x pinnae. The external dimensions are designed to be similar to that of the human head for headphones to provide a consistent and realistic clamp force.
Due to the DIY nature of this project, it is not certified by any standards agency and measurements taken on it will unfortunately not have 100% correlation with industry standard equipment. Still good enough for a bit of fun though.
Assembly:
Print all 3 models
Install KB006x ear onto rectangular cavity on the stand facing outwards
Push IEC60318 coupler and microphone into the round hole on the stand until hitting the flange of the stand
Screw the coupler and microphone onto the KB006x ear until tightly coupled to the flange on the stand
Slide headband support into rectangular hole of the stand from the top, push headband support pin into locking holes to secure headband support in place