Creality Ender 3 Z axis adjustable bracket and pillow block
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Z rod pillow block bracket with micro adjustment.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 467
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This project serves as a proof of concept for micro-adjusting the Z-axis rod on my Ender 3 Pro. I’m now printing at 300 mm/s with 8,000 mm/s² acceleration—no Z-banding issues. While the micro-adjustment is somewhat overkill, it works and dramatically improves print quality. It’s a straightforward, budget-friendly upgrade with a notable impact. Although I’m exploring a redesign, nothing I've tested has been as successful as this setup, so this version stands for now.
Materials Needed:
- Threaded inserts
- M3/M4 nuts
- Flanged pillow block bearing
- M3 screw and washer (for adjustable positioning)
Setup Steps:
- Install all components, starting with the threaded inserts and nuts.
- Use the M3 screw and washer to fine-tune the bearing’s position. This gives you some flexibility to align everything precisely.
- Adjust screws until the Z rod is square and centered.
- Manually move the X gantry up and down to confirm smooth travel.
- Finally, tighten the flanged bearing in place as the last step.
I’ll aim to provide a full step-by-step guide, but for now, these steps should get you set up.