1 / 7
Check valve for AVE VNDC 100 bathroom air extractor - Valvola di non ritorno per aspiratore bagno AVE VNDC 100 — zdjęcie 1
1 / 7

Check valve for AVE VNDC 100 bathroom air extractor - Valvola di non ritorno per aspiratore bagno AVE VNDC 100

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is an accessory to be mounted on the AVE branded bathroom extractor, model VNDC100

Ocena
0 / 5
Polubienia
6
Pobrania
93
Wydruki
0
Wyświetlenia
539
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial

EN:
This is a valve to prevent the air inside the blind bathroom's moisture evacuation duct from flowing back into the house when the bathroom extractor fan is switched off.

Backflow of air from ducts is a problem especially in modern homes where a VMC ducted air system is present.
When VMCs are being exhausted, a vacuum is created in the room which tends to suck air out of the open ducts (kitchen hood and bathroom extractor fan).
This personally tested valve completely solves the backflow problem.

The design was realised to equip AVE extractor fans model VNDC 100 and similar

Printing instructions:
- PETG material
- base filling: 30%
- movable bulkhead filling: 100%
- supports: apply them only to the bulkhead, from the printing plane and only below the pivot pins. After printing, minimal sanding is required to make them perfectly cylindrical again.

IT:
Si tratta di una valvola per evitare che l'aria presente all'interno del condotto di evacuazione dell'umidità del bagno cieco ritorni in casa quando l'aspiratore del bagno è spento.

Il riflusso dell'aria dai condotti è un problema soprattutto nelle case moderne ove sia presente un sistema di aria canalizzata VMC.
Quando le VMC sono in fase di espulsione, si crea in ambiente una depressione che tende a risucchiare aria dai canali aperti (cappa della cucina ed aspiratore del bagno cieco).
Questa valvola, testata personalmente, risolve completamente il problema del riflusso.

Il progetto è stato realizzato per equipaggiare aspiratori AVE modello VNDC 100 e similari

Istruzioni di stampa:
- materiale PETG
- riempimento base: 30%
- riempimento paratia mobile: 100%
- supporti: applicarli solo alla paratia, dal piano di stampa e solo al di sotto dei perni di rotazione. Dopo la stampa è necessario una minima levigatura per farli tornare perfettamente cilindrici.

Tagi