Cactus toothpick holder and Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A design of a cactus in a pot with holes to put toothpicks in, which represent spikes on a cactus.
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 399
- Wydruki
- 1
- Wyświetlenia
- 1937
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
A design of a cactus in a pot with holes to put toothpicks in, which represent spikes on a cactus. Recommended print with no supports and any infill, however I printed mine with low infill. I also printed mine in ABS because if its in the kitchen it might get exposed to water or heat and ABS is better than PLA in those situations. Holder works with most regular toothpicks about 6 cm long and normal diameter. It is printed in one piece but you could change that however due to my printers one color prints I opted to make it all in one go rather than two pieces, a pot and cactus in different color however if I get request's I can change that.