1 / 4
Squash Ball Feet for Flash Forge Adventurer 5M (aka Flash Feet) — zdjęcie 1
1 / 4

Squash Ball Feet for Flash Forge Adventurer 5M (aka Flash Feet)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are anti-vibration feet using squash balls for Flash Forge Adventurer 5M printer

Ocena
5 / 5
Polubienia
25
Pobrania
199
Wydruki
0
Wyświetlenia
1936
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I wanted to have less vibration coming through my new Flash Forge Adventurer 5M printer. I'd previously used Squash Balls on my Prusa Mini+ and wanted to do the same with the 5M.

I liked tterbocharged's design but it was the wrong size for my 5M. So I modified the design so that I could replace the existing feet with the Squash Ball feet.

I used the the original 5M feet as a model and tried to replicate them. 

Although not perfect, the end result works well.

I used PetG to match my existing enclosure. The holes for the screws used with original feet is quite tight. They work, but you could either slightly increase the size of the hole or use a circular file, your call. 

I found the easiest way to fit the feet was to have one side hanging out far enough over the edge of the table to allow me to screw in the replacement. I did this for all sides and only after all feet were installed, did I add the squash balls.

This process was not an easy task and I'm glad it's over!

Once the balls are added, it is not an easy to move the printer so have it in the position you want before you do.

Finally, I did a vibration test. Prior to installing the feet my enclosure door showed significant movement during the test. Once the feet were installed, very little movement was noticed.

I'm very happy with the result.


 

Tagi