U2C board mount for SV08
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed a small mount for the U2C board to mount inside the electronics area on the extrusion next to the main board.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 384
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print Settings
Filament type: PETG or ABS
.4mm nozzle
.20 mm layer height
4 walls
No supports (unless your horizonal screw holes does not print well)
15 percent infill Honeycomb
Harware Needed
for mounting the board to the mount
4 x M3 x 5mm
4 x M3 x 4mm heated inserts
for mounting to extrusion you need the following
2 x M4 x 8mm
2 x T nuts
Assembly instructions: Place your mount first on the extrusion near the mainboard and also connect your power wires on the green power block before mounting the board to the mount.
**just a note I originally designed this with M5 mounting bolts for the extrusion but the T nut i had was for an M4, the mount may seem a bit loose before tightening.