K2 Plus Exhaust, Dual, Single 4" & 2.5" Options
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Exhaust for K2 Plus. Connects with mounting tape and a 2.5" magnetic version.
- Ocena
- 0 / 5
- Polubienia
- 50
- Pobrania
- 464
- Wydruki
- 1
- Wyświetlenia
- 3186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Here are a few options for exhaust/ducting for your K2 Plus.
All-in-one → This is a single large piece which takes the output from both exhausts and takes it down to a single point. Attach your hose/duct and then attach the hose to a venting system or out a window. You must use PETG/ASA/ABS and very strong mounting tape, otherwise it will likely come off at some point.
Split → These are individual pieces which take air from each output. You can then connect two hoses and vent them, or use a Y splitter like the one here https://www.printables.com/model/634619-4in-4-inch-duct-splitter or here https://www.printables.com/model/1099216-25in-25-inch-duct-splitter to connect the two hoses into one. There is also a 2.5" magnetic version that uses 6x 20mm x 3mm magnets. I glued them so they would have direct contact with the printer & they protrude just a little so that mounting tape can also be added (for extra hold and a better seal).
I have not printed any of the 4" versions and don't have a 4" hose so I don't know if they will even fit.