1 / 6
Pi5 50mm fan holder for GeeekPi heatsink — zdjęcie 1
1 / 6

Pi5 50mm fan holder for GeeekPi heatsink

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Toolless clip on holder for a 50x50x10 fan for the GeeekPi passive enclosure/heatsink

Ocena
0 / 5
Polubienia
2
Pobrania
18
Wydruki
0
Wyświetlenia
151
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

When I was searching for a case for the Raspberry Pi 5 I wanted to have one which maximizes passive cooling but also has “large” fan for when passive cooling is not enough.

In the end I went for the GeeekPi passive heatsink and designed my own holder for a 50mm PWM controlled fan which also provides feet to raise the bottom heatsink.

I salvaged the fan from a Lenovo WiGig Docking station (Delta ASB0505HA-01, 5V, 0.3A) but any 50mm x 50mm x 10mm fan should do. If you want to use the same fan, it has the correct JST SH connector but you need to swap the grey and black wires.

Printing

  • Material:
    • I used Prusament PETG-CF but simple PETG should be good enough, I just like the surface finish of the CF.
    • PLA will probably not work because the heatsink will reach around 48°C before the fan turns on at 50° chip temperature, see details here.
  • Nozzle: 0.4mm
  • Infill: 15%
  • Layer Height: 0.2mm
  • Perimeters: 3
  • Orientation: The model is oriented in the correct way for printing. For the different parts to bend without breaking the model needs to be printed upright.
  • Supports: Enable automatic tree support, see screenshot from Prusa Slicer
  • Sample Print:
    I uploaded a sample print which is basically a cut off corner of the model. You can use it to check your print setting. Check with it if the fan fits and if you can snap it over the heatsink.

Installation

Install the fan first into the holder. Then slide the holder sideways from the the sdcard slot side over the Pi/Heatsink until the retention bumps are seated inside the screw heads.

Changelog

  • 2024-11-09: Uploaded first public revision V1/R4 

Tagi