Fowler Toilet Flush Lever (parametric)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lever for the Fowler toilet, so when you press the flush button down, it raises the mechanism which releases the water.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
This replaces the broken lever so the toilet flushes again.
If your Fowler is a different model to mine but is close enough, the openscad source can be adjusted to suit.
Print it at 100% infill or 99 walls, or add your own modifier to do the same for only the central pivot. That's the point with the most stress and will break first, but the slope also needs several top layers so the button doesn't dent it.
PETG is preferred as it's less brittle than PLA. It'll flex a little rather than snap if you press it too hard.
The slope should be smooth so the button slides on it. File it after printing is faster than using a lower print height for the entire piece.