LDO V0.2 Picobilical / Umbilical PCB Mount Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Updated version of Picobilical PCB mount that adds strain relief to the picobilical cable, and supports the connector.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 268
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
The original LDO model is good, but as I watch my prints, I started to get uncomfortable with the amount of movement that the wires are seeing right at the connector. This is a common failure point for a moving cable, and I wanted to improve that. My goal was to find a way to support the cable, and the connector. Additionally, I think the holes for the cable ties make for a cleaner look.
The spacers are the original design with no change, but included here for completeness. Also, make sure to run your cable tie under the tab of the connector.
Printed using standard Voron settings, in ASA. I did not use supports, but i do not think they would hurt as the back side could be seen from the front of the printer. Photos included of the back results without supports. Either way, I am really happy with this improvement, and the cable is solid, without causing any issues.