1 / 1
Skadis T-Nut mount for soldering flux container
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount a soldering flux container to a Skadis board.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 203
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (14)Powiązane
This is a mount for holding a container of soldering flux on the IKEA Skadis board. It's a remix of the Skadis holder for tip tinner (Thermaltronics, 20 g) by Rai but made bigger. Thanks Rai for publishing the FreeCAD file, it made it so easy to adapt.
It uses the Skadis T-Nuts mounting system from 6d6178. You will need one nut and the M2.5 hardware to attach it. I use M2.5x16 screws.