RV Carport Bottom Rail End Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
End cap to keep animals and bugs out of the bottom rails of a Carport
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution
I bought and assembled an Arrow RV Carport. To keep furry little critters and bugs out of the bottom tubes, I created an end cap. I used Microsoft 3DBuilder. The carport is built with rectangle tubing and the corners are slightly rounded (just barely). But 3DBuilder doesn't have chamfer, so after printing, I just used a deburring tool to trim a little off the corners that slide into the tube and gently tapped them in. …worked perfectly.
Just flip it over in your slicer so the closed end is on the plate.
No supports needed.
Print with 100% infill.
Printed with Black PLA.