Wise Glide: Orbital Rig for Wyze Cam Pan

I wanted to see to the left and right of my 3d printer while I was away from my office.

Behold! The Wise Glide: Orbital Rig for Wyze Cam Pan.

Below are all the pieces of hardware you’ll want to get this project off the ground. You can try to print your own wheels, but I didn’t bother. The feet for the rail is friction fit, may need hammers, or glue, depending on your printer. They are beefy because it’s holding a lot of off-balance weight. I’d recommend a decent infill. the gear will fit on a prusa bed by angling it from bottom corner to top opposite corner. Don't forget to print 2 feet!

also check your tolerances, the feet are snug! you may need to scale them up to fit into the posts.

I added a bearing buffer ring for the center wheel, to snug up the mechanics. That should help some.

Wyze Cam Pan: https://www.wyze.com/wyze-cam-pan/
Right-Angle Micro-USB cable. Please note, you will want to hot glue the ribbon onto the moving part of the plug. Mine fell out after a few hours use: https://amzn.to/2SGguOO
Bearings 5mm inner diameter 11mm outer diameter: https://amzn.to/2K3eBb1

Print instructions

Category: 3D Printer Accessories Post-Printing

Wyze Cam Glide in action! a bit bumpy, but it gets the job done.

Here's a shot from the camera itself. Pretty awesome i think.

Here we are looking at the Wyze App, notice how panning left corresponds to orbiting left. no alterations are made to the camera.

Trolley with 5mm (ID) 11mm (OD) bearings, Wyze Cam Pan installed. Gear to the left screws into place.

GENTLY screw the gear onto the camera mount on the bottom of the Pan. Line up the gap for the USB Cable.

Corner positioning surely seems to be the Wise Glide's calling