Rivian left side dash ball mount extension balls & socket head screw compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted the phone closer to me, so I extended the original ball mounts. I had a pile of socket head cap screws too.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 292
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I added a tube to bring the ball farther out from the dash. I tried a few sizes. And I have hundreds of socket head cap screws, but few flatheads, so I made a version that works with those.
These can easily lose bed adhesion and fall over, so I used these brim settings:
Outside only, 25mm, 0.05 separation. It's a little harder to remove but not a big deal.
Printed on a K1C with PA-CF, 0.08 layer, 0.4mm nozzle, no supports, very reduced speeds, temps were 80 and 280. I enabled the contour scarf joint setting to make the seam smooth. Gyroid infill at 80%, 4 walls.
Depending on which length you use, you will need M5 screws that are 50-70mm long, available at Ace in singles for about a dollar, or a pack on Amazon for $8, with various lengths.