RTI Mora and Accessories Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for the RTI Mora with the bottle shield, two magazines, and the Hush moderator.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 382
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
This is a collection of models made for the RTI Mora. It got annoying taking the accessories off and putting it in the case, and putting them back on out of the case. So I made these.
The rifle part will keep it upright and is designed with the bottle shield on. It has a little bit of tolerance in the design but it's very secure.
The magazine holder, while I have made it so the screws sit flush or a little under the surface, the neat part is that if you have them sticking out just a tiny bit you can slot the magazine onto the heads. It's not needed however, the magazines are secured just fine.
The suppressor is only secured to the wall with one screw and has a tendency to rotate. Pretty easy to straighten it though.
I have printed these out in SUNLU Tough PLA v1 and has held up great for the past couple months I've had it mounted. Supports are not needed when printing.