ProStand 4040 - MagSafe & Apple Watch Heatsink Dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Secure, cool, and one-handed! The ProStand 4040 docks your iPhone & Apple Watch with style and heatsink cooling
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 586
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
ProStand 4040 - MagSafe & Apple Watch Heatsink Dock
The ProStand 4040 combines sleek design with practicality, using 4040 aluminum extrusion to securely dock your iPhone and Apple Watch while providing passive cooling. The setup is stable, stylish, and designed for easy, one-handed use with your devices in standby mode. Perfect for desks and charging stations.
Additional Info:
The 4040 extrusion profile I used has a 4mm corner radius, and for a sleek look, the mounts match this radius. Other manufacturers may use a different radius, so also uploaded versions with a smaller radius to accommodate variations.
The MagSafe mount is designed to fit model number A2140. I included models with the dimensions of the newer MagSafe puck models A2580 and A3250, but I haven’t been able to check fitment with these. If you use one of these newer models, please provide feedback on fit! Files are named according to model number and radius for easy selection.
The Apple Watch charger mount is designed for the USB-C fast charger puck (aluminum housing, shipped with Apple Watch Series 7 and later). Older chargers might fit, but note that USB-A cables can’t be routed through the hole in the base.
Required Hardware
-4040 Aluminum Extrusion
Min. length for MagSafe only: 70mm
Min. length for MagSafe & Apple Watch: 110mm
Min. length for Apple Watch only: 45mm
Pictured length: 160mm
-Base & Desk Clamp:
1x M8x15 (or longer) cylinder head screw
2x M4x20 cylinder head screws
1x M8 hex nut
1x M8 screw (length depending on desk thickness)
-Each Charger Mount:
2x M6x14 cylinder head screws
2x M6 profile nuts or sliding blocks
Instructions
I don't recommend the use of PLA for the mounts, as the chargers can generate some heat.
Print mounts “facing down” and add support only to the surfaces parallel to the build plate.
Print clamp on its side and increase number of perimeters.
1. Apple Watch Charger
-Press the Apple Watch charger into its printed holder from the back
-Bolt it to the extrusion and route the cable through the extrusion channel
2. MagSafe Charger
-Slide MagSafe puck into the holder and press in from the back
-Bolt it to the extrusion and route the cable through the extrusion channel
3. Base Assembly
-Guide each cable through the hex hole in the base one at a time
-Cut M8 thread into center bore
-Bolt the base to the extrusion, ensuring cables aren’t pinched
-Feed cables through the hex channel in the desk clamp arm
-Attach the desk clamp to the base
-Insert the M8 hex nut and M8 bolt, then tighten to secure the setup to your desk
I used this endcap by 93djen. Thanks!