Duet 3 6hc and SBC mounting bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slim mounting bracket for a Duet 3 6hc board in combination with a Raspberry Pi 4B
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a slim mounting bracket for a Duet 3 6hc board in combination with a Raspberry Pi 4B or any other SBC for that matter which has the same mounting hole dimensions. There are two versions. The standard Version and one with a little more narrow borehole pattern for mounting. The Bracket is meant to be used with heat set inserts. You need:
- 8 pieces of heat set inserts M4x8.1 mm (or similanr length)
- 4 pieces of heat set inserts M2.5x4 mm (or similar length)
There are also four washers that must be printed to create enough clearance between the mounting bracket and the duet 3 board.
Printing is easy, just make sure you print it the right way up. PETG worked perfectly for me here. PETG V0 would be an even better match.