1 / 7
Bins for Stanley Small Parts Organizer (014725R) — zdjęcie 1
1 / 7

Bins for Stanley Small Parts Organizer (014725R)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Assortment of modified bins to fit the Stanley 014725R 25-compartment organizer.

Ocena
5 / 5
Polubienia
11
Pobrania
65
Wydruki
1
Wyświetlenia
245
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

Description

I am in the process of standardizing all of my hardware and small parts into the Stanley Pro Organizer system of cases. I am a big fan of this system's modularity (and the build quality of these boxes), but I found the standard bin sizes too limited for some use cases.

After living with the system for a bit, I also felt there was room for improvement, specifically:

  1.  Adding a scoop to the bottom to make it easy to grab parts.
  2. Having a lip to stick a label to (which has the added benefit of making a convenient place to grab the bin when removing it from the case).

 

Variations 

Because the bin sizes are asymetric (width vs depth), I have a variations to put the lip and scoop on either the width side (the side running left to right) or the depth side (the side running front to back). 

In practice I would usually opt for putting the label on the shorter side (takes up less volume), but you can opt for either if it's important that all the labels have the same orientation. Personal preference!

I have also exported a few .stl files that do not have a lip for the label. The file names mark those variation. 

 

Naming Conventions:

<# of bins Wide>W x <# of bins Deep>D - [Width Side | Depth Side] .stl

Ex: 2W x 1D - Width Side.stl  makes a bin that is 2 bins wide and 1 bin deep with the lip and a scoop oriented along the "width"  side.

 

Attribution

These models were based almost entirely on the parametric models provided by András Bognár, with some slight tweaks.

 

Source files

I have included the source files from Fusion 360 (.f3d) so you can further modify them. As I mentioned these were mostly created by András, so a big thanks to them!

Tagi