AeroPress Filter & Scoop Holder – Angled Base, Easy Single-Filter Grab
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for AeroPress paper filters and scoop with an angled base for easy single-filter grab. No supports needed, FreeCA
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
A compact holder for AeroPress paper filters and your scoop/spoon, so everything for your brew sits in one place on the counter.
The base is angled, so you can pull out a single filter easily instead of fishing for it or lifting the whole stack.
Features
- Holds a stack of standard AeroPress paper filters
- Dedicated slot for the scoop/spoon
- Angled base for easy one-handed filter grab
- Prints without supports [confirm]
- FreeCAD source file included, so it is easy to adapt to your own setup
Fits
AeroPress Original and AeroPress XL filters [adjust to what you tested]
Print settings
- Material: PLA / PETG
- Layer height: 0.2 mm
- Infill: 15–20 %
- Supports: none [confirm]
- Printed on a Bambu Lab P1S [optional]
Remix friendly
Licensed CC BY-SA 4.0. The editable FreeCAD file is attached. Resize it for the XL filters, add a slot for the stirrer, or change the base angle, and please post your remix or make if you print it.