1 / 4
T2 (M42x0.75) extender ring male (UPDATED) — zdjęcie 1
1 / 4

T2 (M42x0.75) extender ring male (UPDATED)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

T2 (M42x0.75) extender ring with continuous male thread.

Ocena
0 / 5
Polubienia
2
Pobrania
50
Wydruki
0
Wyświetlenia
179
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

T2 (M42x0.75) extender ring with continuous male thread.

To print these parts, I recommend a layer height of 0.12 mm or less.

Speed of external perimeters equal to or less than 40 mm/s.

Check my configuration file to have an orientation of the parameters that give a good result, without forgetting your experience.

STL available in 4 lengths: 12, 16, 20 and 24 mm.

 

UPDATED (2025-08-28)

I added a small slot, which does not affect the functionality of the thread, but allows you to hide the printing seam. Now, the printed thread is completely clean.

It is important to place the piece with the correct orientation and configure the seam at the back (see image). 

Set the nozzle and hot bed temperature, the lowest possible that are compatible with the material you use, to reduce the shrinkage of the piece to a minimum and not lose functionality.

Check my configuration file to have an orientation of the parameters that give a good result, without forgetting your experience.

UPDATED 2 (2026-07-25)

In this update I have added 6 new adapters, from 5 to 10 mm in height.

Have a good astronomical observations!!!

Tagi