1 / 7
Satsana Duct (Ender3 ) for Nebula bracket + cr touch + g sensor
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified the satsana to fit the bracket I made for ender 3 nebula https://www.printables.com/model/912669-nebula-bracket
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 311
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
This is a Satsana duct remix to fit the crtouch holder that also has the vibración sensor from the nebula pad without the need to set a x or y offset as the cr touch stays as in the original place
Same settings as the original this was remixed from, that is some little supports in the part were the screw goes and where the cr touch piece holds to