1 / 5
BOBBY RACER - Realistic, Ultra-Quiet Bobby Car Tires — zdjęcie 1
1 / 5

BOBBY RACER - Realistic, Ultra-Quiet Bobby Car Tires

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Realistic design and super silent tires for original Bobby Car. Printable in TPU or TPE. Mounts on the original wheel!

Ocena
0 / 5
Polubienia
12
Pobrania
86
Wydruki
1
Wyświetlenia
554
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial

BOBBY RACER tires are specifically designed for ultra-quiet performance on indoor surfaces.

Every parent or neighbor of a child with a Bobby Car is familiar with the loud, hard rubber tires they come with. There are pricey alternatives which still aren't as silent as advertised, so I created my own.

Modeled after real car tires, BOBBY RACERs combine a realistic appearance with excellent performance.

Installing the tires is easy: simply pull off the original rubber stretched over the wheels and replace them with BOBBY RACERs (see photo for reference). Note that there are two files: one for the left and one for the right side, as the tread has a specific direction. An arrow pattern on the side shows the correct orientation.

Printable in soft TPU or TPE filament. I achieved great results printing TPE with a Shore hardness of 83A. Commonly available TPU with a hardness of 95A works, but does not result in maximum silence when driving. I recommend using a 10% gyroid infill for unidirection strength. Depending on your filament choice and weight of the driver, vary the number of printed walls and infill percentage. Printable without supports!

With my settings, each tire takes about 6 hours to print and uses 100 g of TPE filament, costing approximately €3 per tire. This brings the total cost to €12 for a complete set—still half the price of the original upgrade tires.

If the fit seems too loose, I’ve included an alternative variant with an inner diameter that is 0.5 mm smaller. I’d love to hear your feedback or suggestions! :)

Never loose traction - Happy Printing!

Tagi