Build plate sheet holder, 5 slots, prints on K1 printers and works with most sheets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of a nicely designed sheet holder, but the original could not fit on my K1C build plate.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 164
- Wydruki
- 0
- Wyświetlenia
- 559
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A good build plate holder that should fit on most printers and with most sheets. Once you clean up the channels, even sticky plates like the holographic ones should fit fine. It's oriented to avoid the clanking chain when the printer goes into the far left side.
K1C, 0.4mm nozzle, 0.20 mm layers, PolyLite PLA, 3 walls (recommend 4), 15% gyroid (I'd do 10% if printing it again). High speed and no supports, no brim.
I haven't decided how or if I will mount it. There are screw holes for the wall or other surface, and 3M VHB should be fine for the side of the printer. I'm rearranging so I'm not sure.