Anycubic Kobra Max 2 Harbor Freight Dial Indicator Hot End Side Attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anycubic Kobra Max 2 Hot end side mount for Harbor Freight dial indicator
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 232
- Wydruki
- 0
- Wyświetlenia
- 908
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
If you're having trouble with your Kobra Max 2 bed level. Remove the metal spacers and install silicone bed leveling mounts. You'll need a dial indicator to fine tune your bed after installing the silicone bed mounts. This mount is for the PITTSBURGH travel machinists dial indicator sold by Harbor Freight. I have not tested the mount on any other brands or models. But, based on my observation it might also fit some dial indicators sold on Amazon like the WEN.
Make sure to orient the model in your slicer before printing to ensure proper strength and quality.
You'll also need to print spacers that are required for the middle two bolts on the bed since the metal spacers that come with the printer are longer in the center.
https://www.printables.com/model/739358-anycubic-kobra-2-max-silicon-bed-spacer-spacers/files
In some cases, your z-offset calibration might need some fine tuning. You'll have to manually loosen or tighten the bed screws. Make sure to square off your gantry and tighten any lose POM wheels before you attempt to level your bed or calibrate your z-offset.
I recommend you run this print every other few prints to check on your bed level and z-offset
https://www.printables.com/model/671915-anycubic-kobra-2-max-bed-level-first-layer-calibra