Vacuum Tool Wall Mount (Miele, Tineco, Festool, etc)

This is a super strong, simple model that mounts to the wall and holds vacuum tools/accessories. I built it for the tools that fit my Miele and Tineco, and it fits smaller tools for my Festool shop vacuum as well. It should work with any accessories with an inner diameter of at least 34mm.

It is designed to mount to the wall with two simple drywall screws, no anchors needed. If you have a stud or concrete feel free to swap out the screws, but do note that the recesses are going to work best with tapered screws of some kind. The lower screw has a longer channel so that the same length of screw can be used in both the top and bottom.

I haven't done any sort of formal strength tests, but I've tugged on this quite aggressively with very minimal deflection, so I'd be surprised if it held any less than 40lbs, even with PLA.

Print Settings

Print flat on the bottom using PLA. I recommend printing a little slower if you're not using an E3D nozzle or similar to ensure the layers bond well to one another. It's designed to be sufficiently strong with PLA, but if you want to use a different material go for it. Whatever material you choose, use 3-5 walls and a reasonable amount of infill (I used 10% 3D Honeycomb, but 10% gyroid or 15-20% grid should be plenty strong). No supports are needed anywhere on this print.