MasterSpool for 1.75 mm Filament
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
releases the filament end
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 29
- Wydruki
- 1
- Wyświetlenia
- 125
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made of three parts, body, lid and screw.
The lid is not twisted, the cable ties remain in the slots provided.
There are three positions to fix the end of the filament around the circumference. The filament is simply pushed through a curved tunnel. There are two tunnels with different curve radii, depending on how soft or brittle the filament is. This ist not my own idea, but I don't remember where I have seen this design.
The spool remains flat on both sides, making it easy to stack. No protruding filament ends.
The screw has a short three start thread, like a jam jar. A 60° turn is enough to fix or open the lid.
The hole for the start of the filament has a slot on the side. When the filament runs out, the extruder pulls the filament out of the spool in a radial direction. This ensures that the filament end detection works.
With large labeling field. If you stick on a piece of carpet tape but leave the protective paper on, you can stick on the filament type label and remove it again without damaging it.
Outer diameter 198 mm, Inner diameter 52.5 mm, Width of the spool 58.2 mm.
Print with PLA or PET-G, 0.3 mm layer height
edit Sept.25: Now with STEP-Files
Translated with DeepL.com (free version)