Tablet/keyboard stand for Minisforum V3

I made this to use with my Minisforum V3.

The perennial problem with all 2 in 1 type tablets is that they suck to use in your lap - this aims to fix that issue. It is a full keyboard, and the trackpoint allows full mouse functionality. I use it in bluetooth mode.

Full functionality of the keyboard is retained, except for the small dock for the wireless 2.4ghz adaptor. The logos that denote switch function and position are covered however, and you have to turn it upside down to charge (inspired by the genius design people at Apple!)

The Minisforum pen attaches with magnets - you'll need 4x 6x2mm magnets, pause the print at the appropriate layer and insert them, then restart the print.

I included slots for 2x 3mm stainless steel rods inside the stand to stiffen it up, but they're probably not necessary. Use the same technique to install as the magnets, pause/insert/resume. 

The angle of the tablet is hopefully a reasonably compromise between desk and lap use. 

The 3d printed part is attached to the keyboard with hot glue currently. This is only a prototype, I'll update this page if I need to make any changes after using it for a while. 

NB - it is too big to fit on a single print plate for my Prusa Mk4 - I had to split it in Prusaslicer with a dovetail joint and glue the pieces together after.

 I would expect this to work with other tablets of a similar thickness (~10mm).

A fusion 360 file is included if you want to modify it to suit other tablets/pens.