Garmin Oregon Power Button (300,400,500 Series)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My both Garmin Oregon devices had a known issue: After some years of operation the rubber of the device becomes…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 144
- Wydruki
- 0
- Wyświetlenia
- 1187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
My both Garmin Oregon devices had a known issue: After some years of operation the rubber of the device becomes brittle and the power button gets defect. There are some options to replace the rubber, but with this thing you can just repair the power button.
The button can be used for the Oregon 300, 400 and 500 series. It will not fit for the 600 and 700 devices.
It is a bit oversized for tight fit in order to provide some protection against rain. If you need it waterproof you will have to glue the button into the housing.
Must be printed with flexible material to allow the button to be pressed! I used TPU for it.
After printing you will have to cut the center pin on the bottom side (those side where the center pin if even with the outer wall) by about 1-2mm in order to avoid that the button of the Garmin is pressed always.
Have fun with it!
Category: Sport & Outdoors