Satechi GaN USB-C 100W PD Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A couple of well fitting flexible mounts for this little power supply
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Standard Digital File License
🟩 🟦 🟦 🟪 🟥 🟧 🟨
I needed a mount for this power supply in my workshop after another power supply was found to be inadequate. This was made from a scan with a Revopoint POP2, post-processed in RevoScan and ExModel Lite. The fit is superb and very snug.
There are two versions, one that mounts via a single screw hole, ideal for hanging from walls or other things and one with two screw holes on each side, so it can be mounted easily in other orientations.
Safety note: This power supply gets warm, so you need to make a judgement call as to if this is safe to use in your environment. If the power supply overheats it may be a safety issue.
The holes in each model are 5.4mm wide.
Both models print with no supports and slip on snugly to the device. There are some holes to help heat escape. I used Fillamentum Flexfill 98A for my print but any TPU will probably do.
If you like my designs or find them useful it would be great if you can support me by joining my club on Printables for at least a month, which gives you access to various extra models for the duration of membership. Another alternative is to buy me a coffee over at ko-fi via this link. Thank you!
🟩 🟦 🟦 🟪 🟥 🟧 🟨