Extended Grip for Light L16 Camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An extended grip for the Light L16 camera, giving you extra surface area to hold onto.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a grip I designed for the Light L16. I found the device, while bulky with lots to hold, was difficult to retain a positive purchase on, especially with my joints.
The grip is secured to the camera with the tripod screw. You may use a threaded heat insert to relocate the tripod mount that the grip will take the place of.
The unused accessory port is covered up by the threaded heat insert. The USB-C and 3.5mm headphone jack is also given some chamfering to make insertion easy.
There is a small 2.5mm mounting pin on the base too, that directly interfaces with the respective hole on the camera.
Enjoy!
Bill of Materials
- ¼" Tripod Screw Quick Screw Adapter - (Amazon affiliate link)
- ¼-20 Threaded Heat Insert - (Amazon affiliate link)
Print and Assembly Instructions
- Print the model right side up, with the grip pointed up wards. (I used PLA filament.)
- Infill: 100%
- Walls: At least 4
- Supports: (Important) Use normal supports.
- Using a soldering iron, insert the heat set threaded insert into the bottom of the grip. Ensure it sits flush before allowing it to cool.
- Place the grip onto the camera, and then use the quick screw adapter to secure it in place.