mushroom lamp portable

Voronoi Mushroom Lamp Remix
Update
i have condensed everything into 1 file and updated the design so that the only support needed is where the light will be seated. the support should already be in the file if you use bambu studio.
the gills need full infill or they will break when trying to lock the head.
all of these settings are done in the file.
everything should be ready to print, just pick your colors  and print :)

solder the wires to the board and the battery before installing. see photos.

-solder 4 wires to the charging board. +, B+, -, B-
-solder the B+ and B- to the battery, (use flux)
-insert battery and seat the board in its position, its tight so use a small flat head to pry it in, or use a little heat. try not to break the board. use hot glue or superglue to make sure it wont move.
-solder the negative from the charging board to the negative of the led.
-feed the positive wire through the switch hole, solder the switch to the positive and add another wire to go from switch to the resistor
-solder resistor to switch and positive led.
-superglue or hot glue everything so nothing will move.
-put the dome inside the mushroom head then put the mushroom head onto the stem and rotate so it locks in. nothing should be moving if the dome is not a tight fit, use a bit of hot glue or superglue.

Feel free to adjust the technical details to better match your project’s specifics. Happy printing!

BOM:
battery 18650 lithium-ion:

https://www.aliexpress.com/item/32820520007.html?

10ohm resistor:

https://www.aliexpress.com/item/1005001652314923.html?

1w led's:

https://www.aliexpress.com/item/1005006282400303.html?

switch 10*15mm SPST 2PIN ON/OFF G130 Boat Rocker:

https://www.aliexpress.com/item/4000122284566.html?

Type-c / Micro USB 5V 1A 18650 TP4056 Lithium Battery Charger Module Charging Board With Protection:

https://www.aliexpress.com/item/1005006655376015.html?