Quick-Change Filament Spool Mount for Enclosures

This is a hanging filament spool mount for Prusa Lack Table Enclosures. It is meant to be screwed/glued/double side taped to the top of the enclosure near the filament hole. It was designed to hold spools hanging with low friction. To assemble, print the base with the baseplate down. I've printed the cylinders with the flat face down as well, with no supports. M3 heat set inserts were used in the ends of the cylinder, then M3x16 bolts were screwed in with Loctite Red Threadlocker with a ~5mm gap between the bottom face of the bolt head and the printed cylinder. These gaps allow for the bolts to slot into the gaps on the top of the main mount, which then you can use as a crossbar to hang filament from. I've screwed the mount bases into the enclosures before, but 3M VHB double sided tape works really well too if you don't want to damage the enclosure. To keep filament dry in this system, a Sterilite 20 Qt. Clear Gasket box was placed face down without the lid over the filament and the filament hole, and desiccant was placed in this space as well. Feel free to message me if you have any questions.