Diesel Heater All-In-One Weather End Shrouds
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For Chinese Diesel Heater all-in-one upright units, such as Vevor, to help with protecting from snow/water on both ends.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 519
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These two shrouds can help protect from snow or rain on the ends of all-in-one Chinese diesel heaters such as made by Vevor. I printed in TPU so if I bump the shrouds, they would hold up and not crack/break like can happen with PLA. I suspect TPU will create a better seal but if needed, a small bead of caulk could also be used. TPU also seems to hold up better for outdoor applications.
You will need to unscrew the two screws on each diesel heater top handle and push each shroud down over the "nuts" that are sticking up, another reason to use TPU because the 6mm holes are purposely designed to be a tight fit so having some flexibility will be helpful. Otherwise, use a drill to slightly enlarge the holes. Put the handles back on and tighten all four screws.
The Ingress End Shroud stands out far enough to where the combustion chamber air intake will be covered if you've zip-tied the intake to the end-wall. You could print two Ingress End Shrouds and use one on each end if you choose where you may be able to better see the attached OEM LCD screen/controller. EDIT (27 Dec 2024): I have reverted to using an ingress end shroud on both ends on my Vevor diesel heater. I also purchased a LCD controller with mount to keep the 2nd controller as a back-up/spare and then installed the 2nd mount to the outside of of the end shroud and I can clip my LCD controller to that mount or keep it covered and clipped in to the original location.
EDIT (27 Dec 2024): I use the longer version of end shroud on both ends of my Vevor diesel heater now but I will leave up both shroud files - The Egress End Shroud is a bit shorter and protects the OEM LCD screen/controller. The only issue with the Egress End Shroud might be seeing the OEM LCD screen/controller. Seeing the OEM LCD screen/controller is not a concern for me as I use a wireless Bureck thermostat controller and do not need to see the OEM LCD screen/controller. You could also consider splicing in a longer section of wiring so you could temp pull the OEM LCD screen/controller out to make adjustments or add a long enough section of wiring to run that controller inside your “living space”, which realistically should be done since the thermostat is inside that OEM LCD screen/controller. Otherwise your thermostat will be reading inaccurately, based on the ambient outside temperature.
These will print on a Prusa Mini sized bed.
I added a fuel cap topper to sit over the Vevor vented fuel cap so no water can get inside the fuel tank. There should not be any concern with water getting onto the outside of the fuel tank, inside the case, and dripping down.